CRL FW292R Ford Transit Connect Van Window 2010-2013 - Passenger Rear Cargo Door

Part # FW292R

Mfg: CRL (CR Laurence)

Mfg Country: USA

Mfg Warranty: 30 Days

Glass Color = Solar Privacy Glass

Glass UV Rating = 28%

 This window is installed with Urethane Adhesive, you will need a primer base, and we recommend edge molding for the cut edge. 

VWD Urethane Installation Kit 

Trim Lock Edge Molding (Approx 6ft)

Window Securing Tape

CRL Ford Transit Connect Van Window

 When replacing an existing factory window, you may want to contact us or provide photos inside and out. Not all replacements will be straightforward and can require extra commendation and custom adaptation to use an existing factory or add-on item(s). Van Windows Direct and the manufacturers we distribute take no responsibility for additional work or an installer's inability to complete the work required. Please ask all questions and provide all information before purchase, as the buyer is 100% responsible for the installation or failure to install.

The Transit Connect Van Window utilizes factory metal stamping; on the van's interior, you will notice an area where the inner metal ends. Here is a photo to clarify. You will cut right along with that edge all the way around. Your van may have multiple uprights. You will cut those out straight with your opening.

If you are replacing an existing factory window that was glued in, you may want to take it to a professional for removal and replacement. The best tool to use is a wire cutter  Equalizer Window Cut-Out Set. Once the window is cut out, you will need to cut the original urethane down as flat as possible and clean as much away as possible with CRL Adhesive Cleaner. 

Once the Hole has been cut out or the window removed, it's time to install the new window. 

The CRL Window utilizes a trim ring (clamp ring) installation. Before putting the window on the van, it's best to go through and make a small pilot hole in all the locations around the trim ring. That way, you do not round the heads of the screws when tightening the window. 

Put the Window in place from the outside Van, allowing the aluminum mounting frame to extend through a hole in the wall. Place the clamp ring from the inside. Most vans will have the split on the bottom. With one person holding the window in place on the outside, the other can start the screws from the inside generally, starting with the two at the split in the trim ring to have that lined up, then top and around. You do not want to fully tighten once all screws are in place; you can then go back around and tighten them. Be sure to tighten evenly around for proper seal.