CRL Ford Transit Van Window Medium / High Roof 2015-2023
CRL Ford Transit Van Windows is configured to fit within the Ford Transit Vans OEM stamping and provide a customized OEM look. This great feature eliminates the time-consuming efforts of laying out where the window will be installed. Just line it up to cut, starting on the upper inner dimple, and follow along with the OEM stamping. T-Vent has a T-Handle to open the glass like a canopy to allow airflow, the Vent features a detachable screen.
- FW293R-PASSENGER SLIDING DOOR = T-VENT (will not replace existing window)
THE FRONT TOP CORNER MUST BE CUT SMALL, USE THE CLAMP RING FOR REFERENCE.
Note Rear Cargo Door Windows are Urethane Bonded
All Side Windows are the traditional clamp ring install
Mfg. # CRL (CR Laurence)
Mfg. Country: USA
Mfg. Warranty: 30 Days
Glass Color = Solar Privacy Glass
Glass UV Rating = 28% Allowable UV
CRL Ford Transit Van Windows - CR Laurence Company
|What's needed to Install it?|
No additional products are required for installation. Except for Rear Cargo Doors = Urethane Primer
|How will I install this window?|
The Ford Transit Van Window utilizes factory metal stamping, on the interior of the van you will notice an area where the inner metal ends. Here is a photo to clarify. You will cut right along with that edge all the way around your van may have multiple uprights you will cut those out straight with your opening.
When replacing an existing factory window, you may want to contact us or provide photos inside and out. Not all replacements will be straightforward and can require extra commendation and custom adaptation to use an existing factory or add-on item(s). Van Windows Direct and the manufacturers we distribute take no responsibility for additional work or an installer's inability to complete the work required. Please ask all questions and provide all information before purchase, as the buyer is 100% responsible for the installation or failure to install.
If you are replacing an existing factory window that was glued in you may want to take it to a professional for removal and replacement. The best tool to use is a wire cutter Equalizer Window Cut-Out Set. Once the window is cut out you will need to cut the original urethane down as flat as possible and clean as much away as you can with CRL Adhesive Cleaner.
Once the Hole has been cut out or the window removed it's time to install the new window.
The CRL Window utilizes a trim ring (clamp ring) installation. Before putting the window on the van it's best to go through and make a small pilot hole in all the locations around the trim ring that way you do not round the heads of the screws when tightening the window.
Put the Window in place from the outside of Van allowing the aluminum mounting frame to extend through the hole in the wall. Place the clamp ring from inside most vans will have the split on the bottom. With one person holding the window in place on the outside the other can start the screws from the inside generally start with the two at the split in the trim ring to have that lined up then top and around you do not want to fully tighten once all screws are in place, you can then go back around and tighten them be sure to tighten evenly around for proper seal.
Standard Shipping times 1-2 Week Lead Time , with a 1-5 Day Travel Time. (Subject to change due to supply chain issues)