CRL Sprinter Van Windows 2002-2006
- High Roof and Low Roof Models
- Short or Long Wheel Base
- 30 Day Warranty
CRL windows are configured to fit within the 02-06 Sprinter Vans OEM stamping and provide a customized OEM look. This great feature eliminates the time-consuming efforts of laying out where the Window will be installed. Just line it up to cut, starting on the upper inner dimple, and follow along with the OEM stamping. T-Vent has a T-Handle to open the glass like a canopy to allow airflow; Vent has a screen-less design. Solar Privacy Tint Glass
CRL Sprinter T1N Van Windows
|Window Position||Wheel Base||Window Type|
|FW601||Driver Side Forward||ALL||Screenless T-Vent|
|FW603L||Driver Side Rear Cargo Door||ALL||Solid|
|FW605||Passenger Sliding Door||ALL||Solid|
|FW603R||Passenger Side Rear Cargo Door||ALL||Solid|
What's needed to Install it?
How will I install this Window?
The Sprinter Van Windows 2002 2003,2004,2005,2006 Window utilizes factory metal stamping; on the van's interior, you will notice an area where the inner metal ends. Here is a photo to clarify. You will cut right along with that edge around. Your van may have multiple uprights. You will cut those out straight with your opening.
When replacing an existing factory window, you may want to contact us or provide photos inside and out. Not all replacements will be straightforward and require extra commendation and custom adaptation to use an existing factory or add-on item(s). Van Windows Direct and the manufacturers we distribute take no responsibility for additional work or an installer's inability to complete the work required. Please ask all questions and provide all information before purchase, as the buyer is 100% responsible for the installation or failure to install.
If replacing an existing factory window glued in, you may want to take it to a professional for removal and replacement. The best tool to use is a wire cutter Equalizer Window Cut-Out Set. Once the Window is cut out, you will need to cut the original urethane down as flat as possible and clean as much away as possible with CRL Adhesive Cleaner.
Once the Hole has been cut out, or the Window removed, it's time to install the new Window.
The CRL Window utilizes a trim ring (clamp ring) installation. Before putting the Window on the van, it's best to go through and make a small pilot hole in all the locations around the trim ring. That way, you do not get rounded heads of the screws when tightening the Window.
Tape your window installation foam on the backside of your Window next to the aluminum frame so it will get sandwiched between the outside glass of the Window and the body of your van
Put the Window in place from the outside of the Van, allowing the aluminum mounting frame to extend through a hole in the wall. Place the clamp ring from the inside. Most vans will have the split on the bottom. With one person holding the Window in place on the outside, the other can start the screws from the inside generally, beginning with the two at the split in the trim ring to have that lined up then top and around. You do not want to tighten once all screws are in place fully, you can then go back around and pull them be sure to tighten evenly around for proper seal.
Standard Shipping times 1-2 Week Lead Time , with a 1-5 Day Travel Time. (Subject to change due to supply chain issues)